No Entry remote for my 2006 Armada [Archive] - Nissan Armada Forum: Armada & Infiniti QX56 Forums

: No Entry remote for my 2006 Armada


phfab0
11-17-2009, 11:40 PM
Please can the forum help me on how to get and program 2006 Nissan keyfob.I reside in Nigeria and my remote was lost during shipping. Kindly help out.

kenedytxarmada
11-18-2009, 12:46 AM
You can find them on Ebay for a good price and most sellers will include the programming instructions as well............

kenedytxarmada
11-18-2009, 12:47 AM
Please can the forum help me on how to get and program 2006 Nissan keyfob.I reside in Nigeria and my remote was lost during shipping. Kindly help out.

How much does a gallon/litre of gas go for in Nigeria?????

BlakSpyda
11-18-2009, 12:43 PM
Welcome to CA phfab0!

What kenedytexarmada said is true. Good luck with that though!

gsharma00
11-18-2009, 03:40 PM
Good luck with finding the key. Try ebay, and Amazon they may work for you, i just hope that you dont get robbed when you ship over seas. but here are some instructions that i found on the internet, I have used this be4 also and it worked for me.

1. Close and lock all doors with the driver’s side power lock/unlock switch.

2. Insert key into ignition and remove it from the ignition key cylinder at least six times within 10 seconds. Your Hazard Lamps will flash if you have performed this step successfully. NOTE: Withdraw key completely from ignition cylinder each time. If this procedure is performed too fast, system will not enter programming mode.

3. Insert key into the ignition cylinder and turn to the ACC position.

4. Within 5 seconds, push ANY button on the remote transmitter. Your Hazard Lamps should flash. NOTE: Do not pressthe button more than one time in the above step. If the button is pressed more than one time, the programming procedure will not be successful.

5. If there are any remaining transmitters (including the old ones), unlock then lock all doors using the driver’s side power lock/unlock switch and within 5 seconds, push ANY button on the next remote. Your Hazard Lamps should flash. Repeat this step for each transmitter (including any existing transmitters).

6. Turn the key to the OFF position, remove keys from the ignition, unlock doors using the driver’s side power lock/unlock switch and open the driver side door.

phfab0
11-19-2009, 01:50 AM
Thanks. I will try it.