There was a post recently about someone's sway bar bolts being out of torque and it causing some shimmy in the front end. Has anyone else run into this and does any one know the proper ft/lbs or nm for the bolts?

I don't know which bolts you are asking about. The attached drawing gives the torque values. The values are indicated by the wrench symbol. The third number is the value in ft. lbs.

Thanks scr38, to be perfectly honest I couldn't remeber which bolts were discussed, but that diagram gives me the info I need to check them (all of them) on my own. I've been getting some frint end wiggle so I thought I would begin eliminating problems.