Vetter
03-15-2007, 10:39 PM
Post install of the single-out cat-back Gibson on my 04 Armada 2WD.
The system sounds great and I’ve noticed quite a bump in the throttle response.
I thought I had it installed just right, but I’ve noticed a few things post install. Just wanted to see if these were common occurrences. I plan on having it welded up this weekend and want to make sure I have it installed right before hand.
Thanks in advance for your feedback.
1. When installing the front pipe to the CATs it did not align perfectly. It didn't take much to get each side on and tightened, but it seemed tighter than I expected. Is this common?
2. If properly installed how close should the pipe be from the spare tire? I've noticed that it runs real close after the system heats up.
3. I’ve also noticed a vibration that comes and goes at idle when I have a passenger in the car. This also happens after the system heats up. I’m assuming I need to fine tune the fit over the rear axle and frame rail.
3. Can anyone share a picture of where the pipe exits on the rear of their vehicle? Mine seems to be to far forward and I noticed this evening that the rear AC unit may end up dripping in the Stainless tip.
4. The vehicle seems to idle higher after the install. I'm assuming that this will settle out after a few more miles.
Again.. The systems sounds great, I just want to make sure I have it installed right..
The system sounds great and I’ve noticed quite a bump in the throttle response.
I thought I had it installed just right, but I’ve noticed a few things post install. Just wanted to see if these were common occurrences. I plan on having it welded up this weekend and want to make sure I have it installed right before hand.
Thanks in advance for your feedback.
1. When installing the front pipe to the CATs it did not align perfectly. It didn't take much to get each side on and tightened, but it seemed tighter than I expected. Is this common?
2. If properly installed how close should the pipe be from the spare tire? I've noticed that it runs real close after the system heats up.
3. I’ve also noticed a vibration that comes and goes at idle when I have a passenger in the car. This also happens after the system heats up. I’m assuming I need to fine tune the fit over the rear axle and frame rail.
3. Can anyone share a picture of where the pipe exits on the rear of their vehicle? Mine seems to be to far forward and I noticed this evening that the rear AC unit may end up dripping in the Stainless tip.
4. The vehicle seems to idle higher after the install. I'm assuming that this will settle out after a few more miles.
Again.. The systems sounds great, I just want to make sure I have it installed right..