Man isn't it. Boy does it stay cooler on the gauge. And not even by a little bit.
Point of note: I'm not super happy with the factory clamps I reused, or the worm clamps from the kit that went in where the factory bits were too far gone. I'd found a link in the Titan Talk thread for a part# from OReiley's Auto for EFI hose clamps, but it was a dead link and I couldn't find them. So, I bought a dozen (more than I need for this job) and I'm going to redo all the hose connections tomorrow.
If anyone's doing this soon, here's the info from NAPA to get the proper parts:
Hose Clamps, Fuel Injection; #16
Clamp Size Range : 9/16"-5/8"
Hose Size Range : 3/8"
These are SO much better than worm clamps.