Mine is horribly cracked and not willing to pay the $400+ people are asking for a piece of plastic. Hoping someone has one for a QX56, which I believe is a little different from the Armada bezels. Pic attached for reference.
Joined
·
39 Posts
Man, I am in the same boat as you.
Joined
·
14 Posts
I’ve been watching my local junkyards for QX56s. One JUST came in this morning and by the pics, it looked intact. By the time I got there 3 hours later, it was already gone 
Joined
·
39 Posts
I am gonna try to model it up and 3D print a "stitch plate" to go across the top and about a quarter down both sides.I’ve been watching my local junkyards for QX56s. One JUST came in this morning and by the pics, it looked intact. By the time I got there 3 hours later, it was already gone
Joined
·
14 Posts
That would be interesting. What do you mean by “stitch plate”?
Joined
·
39 Posts
The top of my bezel is what is busted up. The "Stitch Plate" will span the top of the bezel and possibly down each side 1/4th of the way down. Behind the the bezel, where the screws will go through, I will epoxy a thin sheet metal plate to screw to. The top side as stated above, would be 3D printed from PET-G or ABS, either can withstand the heat of being in the window. The very top side would ne designed so accessories coul be attached. Like a portable CarPlay radio, or a cell phone mount.
Joined
·
14 Posts
I’d be interested to see a mock up of your design. It’s frustrating that the regular non-navigation bezel is readily available aftermarket for around $60 but ours is nonexistent.
1 - 7 of 7 Posts
Join the discussion
