Nissan Armada & Infiniti QX56 Forums banner
1 - 2 of 2 Posts

· Premium Member
Joined
·
3,590 Posts
Notice no data below 3000 rpm. Wonder if that is because there is a power loss at lower rpms? And, where do you spend most of your time? Above or below 3000 rpm? Especially when you tow!

Keith
 

· Premium Member
Joined
·
3,590 Posts
AEMTech said:
I am the engineer responsible for designing this kit. As for that dip early in the curve, there is a simple explanation. The Titan dyno'ed had, of course, an automatic transmission. ATs can cause some problems at the begining of a dyno run. Before the run, the throttle is closed, as soon as the run starts, the throttle is punched and sometimes the torque converter slips or locks at the begining of the run. This causes inconsistencies in the begining of the dyno chart. That is what happened when the AEM intake was dyno'ed. I have driven the Titan with the intake installed, and believe me, you have not lost any low end power with it installed. Ask morpheus if you don't believe me. I would have prefered to dyno a manual Titan, but those don't exist. An MT offers more consistant dyno charts.

Hope this helps.

Thanks guys!!!
Why no data below 3000 rpm?

Keith
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top