Headrest monitor

1664 Views 2 Replies 3 Participants Last post by llajumpvid, Jul 15, 2005

GTArmada

Discussion Starter · Jul 14, 2005

Ok guys, i bought a pair of Headrest monitor for the Armada, it will replace the factory headrest. The only thing i can't figure out is how i'm gonna run the wires in the seat, is there a way to remove the covering for the front seats so i can get the wire at the bottom of the seat. Pls let me know guys.

Thanks.

Save

1 - 3 of 3 Posts

rp718

· #2 · Jul 15, 2005

You might try a small-size fish tape, like what electricians use to pull wires through walls and conduit. Home Depot sells various sizes in their electrical dept, and I suspect it might work for you.

Good luck.

Save

llajumpvid

· #3 · Jul 15, 2005

this might help you out http://www.geocities.com/armadafication/AV_Mods.html

Save

1 - 3 of 3 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Home
Forums
Nissan Armada Forums
General Discussions

Top Contributors this Month